Starter Cut Relay: Testing and Inspection

STARTER CUT RELAY INSPECTION [MTX]

1. Disconnect the negative battery cable.

2. Remove the following parts:

- Front scuff plate (LH) Front Scuff Plate Removal/Installation
- Front side trim (LH) Front Side Trim Removal/Installation
- Side wall Side Wall Removal/Installation
- Console Console Removal/Installation

3. Set the hood release lever out of the way. Service and Repair

4. Remove the lower panel. Lower Panel Removal/Installation

5. Remove the starter cut relay. Service and Repair

6. Verify that the continuity is as indicated in the table.






- If not as indicated in the table, replace the relay.