Clutch Pedal Position Sensor / Switch: Testing and Inspection

CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION [LF, L3]

NOTE:
- Before performing the following inspection, make sure to follow the troubleshooting flowchart. Foreword

Continuity Inspection

1. Disconnect the CPP switch connector.

2. Verify that the continuity between CPP switch terminals A and B is as indicated in the table.






- If there is no malfunction, perform the "Circuit Open/Short Inspection".
- If there is any malfunction, replace the CPP switch.





Circuit Open/Short Inspection









1. Disconnect the PCM connector.

2. Disconnect the CPP switch connector.

3. Inspect the following wiring harnesses for an open or short circuit. (Continuity inspection)

Open circuit

- If there is no continuity in the following wiring harnesses, there is an open circuit. Repair or replace the wiring harness.

- CPP switch terminal A and PCM terminal 1D
- CPP switch terminal B and body ground

Short circuit

- If there is continuity in the following wiring harnesses, there is a short circuit. Repair or replace the wiring harness.

- CPP switch terminal A and body ground
- CPP switch terminal A and power supply
- CPP switch terminal B and power supply