Meter Hood Removal/Installation

METER HOOD REMOVAL/INSTALLATION

1. Remove the following parts:
a. Front scuff plate (Driver's side) (See Front Scuff Plate Removal/Installation.)

b. Front side trim (Driver's side) (See Front Side Trim Removal/Installation.)

c. Decoration panel (See Decoration Panel Removal/Installation.)

d. Hood release lever Service and Repair

e. Lower panel (See Lower Panel Removal/Installation.)

2. Detach the fit of the meter hood rubber from the upper column cover.

3. Pull the meter hood outward and detach the tabs A and locator pins B.






4. Remove the meter hood.

5. Install in the reverse order of removal.