DTC Inspection [Control System]

DTC INSPECTION [CONTROL SYSTEM]




1. Connect the M-MDS to the DLC-2.
2. Verify the following vehicle conditions:
- All the switches are turned off (except the ignition switch).
- All the doors, bonnet, and lift-gate are closed.
- All the doors, and lift-gate are unlocked.
- All the seat belts are unbuckled.
- Parking brake lever is pulled.

3. Start the engine.
4. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
1. Select "Self Test'.
2. Select "Modules".
3. Select "GEM".

- When using the PDS (Pocket PC)
1. Select "Module Tests".
2. Select "GEM".
3. Select "Self Test".

5. Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

6. After completion of repairs, clear all DTCs stored in the BCM. (See CLEARING DTC [CONTROL SYSTEM]) Clearing DTC [Control System]