Rear Drain Hose Installation

REAR DRAIN HOSE INSTALLATION

CAUTION:
- If the rear drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and after installation of the trims and the headliner, always make sure there is no interference with the rear drain hose. Fix any problem if found.

1. Apply soapy water to the rear drain hose inserting area.

2. Insert one end (the wider side) of the rear drain hose into the sunroof frame.

3. Install the rear drain hose to the clips parallel to the pillar and free of slack.

4. Insert the rear drain hose joint into the rear pillar inner hole.

5. Install the following parts:
a. Headliner Service and Repair

b. Assist handle Service and Repair

c. Sunvisor Service and Repair

d. Map light Service and Repair

e. D-pillar trim D-Pillar Trim Removal/Installation

f. C-pillar trim C-Pillar Trim Removal/Installation

g. Trunk side trim

h. Trunk end trim Trunk End Trim Removal/Installation

i. Sub trunk box Sub Trunk Box Removal/Installation

j. Rear seat Rear Seat Removal/Installation

k. B-pillar upper trim B-Pillar Upper Trim Removal/Installation

l. Front seat belt upper anchor installation bolt Front Seat Belt Removal/Installation

m. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

n. Rear scuff plate inner Rear Scuff Plate Removal/Installation

o. Front scuff plate inner Front Scuff Plate Removal/Installation

p. A-pillar trim A-Pillar Trim Removal/Installation

q. A-pillar lower trim A-Pillar Lower Trim Removal/Installation

6. Install the seaming welt.