Removal and Replacement

ENGINE MOUNT REMOVAL/INSTALLATION - 2.5L









1. With the vehicle in NEUTRAL, position it on a hoist. See Lifting.





2. Install the Engine Support Bar.

3. Remove the engine mount bracket bolt.

- To install, tighten to 115 Nm {11.7 kgf-m, 85 ft-lbf}.





4. Use the Engine Support Bar to raise the engine 25 mm (0.98 in).

5. Remove the 3 nuts and the engine mount bracket.

- To install, tighten to 115 Nm {11.7 kgf-m, 85 ft-lbf}.

6. Remove the 3 bolts and the engine mount.

- To install, tighten to 48 Nm {4.9 kgf-m, 35 ft-lbf}.

7. To install, reverse the removal procedure.