Pinpoint Test 2: DTC B1359 - No Power In ACC
PINPOINT TEST 2: DTC B1359 - NO POWER IN ACCNormal Operation
The ignition switch ACC circuit provides fused battery voltage along circuit (V/G) to the smart junction box (SJB) when the key is in the ACC position.
^ DTC B1359 Ignition RUN/ACC Circuit Failure - If, during normal operation the SJB detects an open or a short to ground in the RUN or ACC circuit, DTC 81359 will be set. The DTC will also be set if the SJB does not detect the RUN signal during the on-demand self-test.
This pinpoint test is intended to diagnose the following:
^ Wiring, terminals or connectors
^ Ignition switch
^ SJB
Caution:
^ Use the Flex Probe Kit for all test connections to prevent damage to the wiring terminals. Do not use standard multimeter probes.
