Pinpoint Test 6

PINPOINT TEST 6: INCORRECT TACHOMETER INDICATION

Normal Operation
The tachometer indicates engine speed in revolutions per minute (rpm) ranging from 0 to 7,000 rpm. The engine speed data is sent from the powertrain control module (PCM) to the instrument cluster over the high speed controller area network (HS-CAN) communication bus. The instrument cluster, upon receipt of the engine speed signal, commands the tachometer pointer to the corresponding position. The instrument cluster sets DTC U0100 in continuous memory if the engine speed data is missing for more than 5 seconds or if invalid data is received and the tachometer indicates 0 rpm.

This pinpoint test is intended to diagnose the following:
- PCM
- Instrument cluster

Step 1-Step 4:

Step 5-Step 6: