Pinpoint Test 13

PINPOINT TEST 13: RH TURN SIGNAL INDICATOR IS NEVER ON

Step 1-Step 2:

Step 3-Step 4:

Normal Operation
When the multifunction switch is in the RH TURN position, voltage is sent from the multifunction switch to the instrument cluster through circuit (GY/Y), and the RH turn signal indicator flashes on and off. The instrument cluster provides the bulb ground through circuit (B/Y).

Possible Causes
- Bulb
- Circuit (GY/Y) open
- Circuit (B/Y) open
- Instrument cluster

CAUTION: Use the correct probe adaptor(s) when making measurements. Failure to use the correct probe adaptor(s) may damage the connector.