Pinpoint Test 3: DTCs C1145, C1155, and C1230 Wheel Speed Sensor Circuit Failure
PINPOINT TEST 3: DTCS C1145, C1155, AND C1230 WHEEL SPEED SENSOR CIRCUIT FAILURENormal Operation
The wheel speed sensor and the wheel speed sensor ring generate a signal that is sent to the anti-lock (ABS) module. The wheel speed sensor circuitry connects to the ABS module connector through 2 wires and a connector at each wheel speed sensor. When the ignition is turned to the RUN position, the ABS module carries out a self-test by sending a reference voltage through the wheel speed sensors and their circuitry to determine if they are functional.
Possible Causes
^ Circuit open
^ Circuit shorted
^ Wheel speed sensor
^ ABS module
Caution:
^ Use the Flex Probe Kit for all test connections to prevent damage to the wiring terminals. Do not use standard multimeter probes.
Step 1-Step 2:
Step 3-Step 4:
Step 5-Step 6:
