Luggage Compartment Lid Release Switch - Exterior

Luggage Compartment Lid Release Switch - Exterior









Removal and Installation

1. Disconnect the license plate lamp electrical connectors on the backside of the luggage compartment lid.

2. Disconnect the luggage compartment lid trim electrical connector and push the grommet through the luggage compartment lid.

3. Remove the 4 nuts and the luggage compartment lid moulding.
- To install, tighten to 5 Nm (44 lb-in).

4. Disconnect the luggage compartment lid release switch electrical connector.

5. Press the tab and remove the luggage compartment lid release switch.

6. To install, reverse the removal procedure.