Removal

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE CONSOLE BOX

HINT
Refer to the instructions for Removal of the console box Removal.

3. REMOVE NO. 2 REAR AIR DUCT (for Automatic Transmission) Removal

4. REMOVE NO. 2 REAR AIR DUCT (for Manual Transmission) Removal

5. REMOVE YAW RATE AND ACCELERATION SENSOR

(a) Separate the 2 wire harness clamps.





(b) Remove the 2 bolts and yaw rate and acceleration sensor.

NOTICE:
Do not remove the sensor from the bracket.

(c) Disconnect the connector.