Removal

NETWORKING: NETWORK GATEWAY ECU: REMOVAL

REMOVAL
NOTE:
When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment Service Precautions.
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Repair Instruction - Initialization.

2. REMOVE FRONT DOOR SCUFF PLATE
HINT: Removal procedure of the RH side is the same as that of the LH side Removal.

3. REMOVE FRONT DOOR OPENING TRIM COVER
HINT: Removal procedure of the RH side is the same as that of the LH side Removal.

4. REMOVE SIDE INSTRUMENT PANEL Removal
5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
6. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal
7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal
8. REMOVE NETWORK GATEWAY ECU
(a) Disconnect the connector.

(b) Disengage the 2 claws and remove the cover.