Installation
PARKING BRAKE: PARKING BRAKE CABLE: INSTALLATION
INSTALLATION
1. INSTALL CABLE SUPPORT BRACKET
(a) Install the cable support bracket with the 2 nuts.
Torque: 76 Nm (775 kgf-cm, 56 ft-lbf)
2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
(a) Install the 2 cable support brackets to the No. 3 parking brake cable assembly.
(b) Install the No. 3 parking brake cable assembly to the cable support bracket with the 2 nuts.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(c) Install the No. 3 parking brake cable assembly to the body with the 2 bolts and 2 clamps.
Torque: 19 Nm (194 kgf-cm, 14 ft-lbf)
3. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR Installation
4. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY
HINT: Use the same procedure for the No. 3 parking brake cable assembly.
5. INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR Installation
6. APPLY HIGH TEMPERATURE GREASE Reassembly
7. INSTALL PARKING BRAKE SHOE LEVER SUB-ASSEMBLY Reassembly
8. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY Reassembly
9. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY Reassembly
10. INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET Reassembly
11. INSTALL NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING Reassembly
12. INSTALL NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING Reassembly
13. INSPECT PARKING BRAKE INSTALLATION Reassembly
14. INSTALL REAR DISC Installation
15. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY Reassembly
16. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY
(a) Pass the No. 1 parking brake cable assembly through the parking brake control pedal assembly, and install the clip to the No. 1 parking brake cable assembly.
(b) Install the No. 1 wire adjusting nut to the No. 1 parking brake cable assembly.
(c) Bend the claw of the parking brake control pedal assembly to hold the No. 1 parking brake cable assembly.
17. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY
HINT: Refer to the instructions for Installation of the parking brake control pedal assembly Installation.
18. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)