Integration Control and Panel Assembly Power Source Circuit

AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: Integration Control and Panel Assembly Power Source Circuit

Integration Control and Panel Assembly Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the integration control & panel assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT INTEGRATION CONTROL & PANEL ASSEMBLY




(a) Disconnect the integration control & panel assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE