Washer Nozzle (for Front Side)

WIPER / WASHER: WASHER NOZZLE (for Front Side): ADJUSTMENT

PRECAUTION OF WASHER NOZZLE ADJUSTMENT

(a) Do not clean or adjust the washer nozzle with a safety pin, etc. for the following reasons:

(1) The washer nozzle tip is made of resin and could be damaged.

(2) Adjustment is not necessary for this spray-type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.

1. REMOVE WASHER NOZZLE SUB-ASSEMBLY Removal

2. ADJUST WASHER NOZZLE SUB-ASSEMBLY

(a) Select a washer nozzle so that the contact area is within the standard. Replace the washer nozzle with the selected one.





Text in Illustration





3. INSTALL WASHER NOZZLE SUB-ASSEMBLY Installation