Installation

AXLE AND DIFFERENTIAL: FRONT DIFFERENTIAL CARRIER ASSEMBLY: INSTALLATION

1. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY

(a) Install the front No. 3 differential support with the 2 bolts.

Torque : 108 Nm (1101 kgf-cm, 80 ft-lbf)

(b) Install the front No. 2 differential support with the 2 bolts.

Torque : 160 Nm (1632 kgf-cm, 118 ft-lbf)

(c) Install the front No. 1 differential support with the 3 bolts.

Torque : 186 Nm (1899 kgf-cm, 137 ft-lbf)

(d) Support the front differential with a jack.

(e) Install the 2 front mounting bolts and 2 nuts.

Torque : 137 Nm (1400 kgf-cm, 101 ft-lbf)

(f) Connect the actuator hose and connector.

(g) Install the No. 1 front differential mounting nut.

Torque : 87 Nm (889 kgf-cm, 64 ft-lbf)

(h) Install the front differential breather tube bracket with the bolt.

Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

(i) Lower the jack.

2. INSTALL FRONT PROPELLER SHAFT ASSEMBLY

(a) Install the front propeller shaft assembly Installation.

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY

(a) Install the front drive shaft assembly Installation.

4. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH

(a) Install the front lower No. 1 suspension arm sub-assembly Installation.

5. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

HINT
Use the same procedure described for the LH side.

6. CONNECT TIE ROD END SUB-ASSEMBLY LH

(a) Connect the tie rod end sub-assembly LH Installation.

7. CONNECT TIE ROD END SUB-ASSEMBLY RH

(a) Connect the tie rod end sub-assembly RH Installation.

8. INSTALL FRONT SPEED SENSOR

(a) Install the front speed sensor Installation.

9. INSTALL FRONT WHEEL

Torque : 112 Nm (1137 kgf-cm, 82 ft-lbf)

10. ADD DIFFERENTIAL OIL Service and Repair

11. CHECK FOR DIFFERENTIAL OIL LEAKAGE

12. INSTALL REAR ENGINE UNDER COVER ASSEMBLY Installation

13. INSTALL NO. 1 ENGINE UNDER COVER Installation

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. CHECK SPEED SENSOR SIGNAL

(a) Check the speed sensor signal Test Mode Procedure.

16. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment Front Wheel Alignment.