Installation

SUSPENSION CONTROL: HEIGHT CONTROL SENSOR: INSTALLATION

1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

(a) Install the height control sensor with the 2 bolts.





Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

Text in Illustration





NOTICE:
Replace the rear height control sensor sub-assembly with a new one if it is dropped.

(b) Align the matchmarks on the link and bracket.

(c) Connect the sensor link with the nut.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(d) Connect the connector, and then attach the connector.

NOTICE:
Securely connect the connector.

(e) Attach the clamp.

2. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

HINT
Use the same procedure described for the LH side.

3. INSTALL REAR WHEEL Installation

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. ADJUST VEHICLE HEIGHT Suspension Control System (w/ Air Suspension)