Removal

1UR-FE STARTING: STARTER: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
* w/ Navigation System:
After the engine switch is turned off, the display and navigation module display (navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

(a) Remove the exhaust manifold sub-assembly RH Removal.

3. REMOVE STARTER COVER

(a) Remove the 3 bolts and starter cover.





4. REMOVE STARTER ASSEMBLY

(a) Detach the starter wire clamp.





(b) Remove the nut and disconnect the starter wire.

(c) Disconnect the starter connector.

(d) Remove the 2 bolts and starter.





5. REMOVE FLYWHEEL HOUSING SIDE COVER