Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
* w/ Navigation System:
After the engine switch is turned off, the display and navigation module display (navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH Removal

3. REMOVE COWL SIDE TRIM BOARD RH Removal

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

6. REMOVE LOWER INSTRUMENT COVER LH Removal

7. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Remove the 3 bolts.





(b) Detach the 6 claws and remove the instrument panel airbag.

(c) Disconnect the connector.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.