Installation

1UR-FE EMISSION CONTROL: PCV VALVE: INSTALLATION

1. INSTALL PCV VALVE SUB-ASSEMBLY

(a) Apply a light coat of engine oil to the O-ring.





Text in Illustration





HINT
* When reusing the PCV valve, inspect the O-ring.
* If the O-ring has scratches or cuts, replace the PCV valve.

(b) Using a 22 mm ball joint lock nut wrench, install the PCV valve sub-assembly.

Torque : 3.5 Nm (36 kgf-cm, 31 in-lbf)

NOTICE:
Use the formula to calculate special torque values for situations where ball joint lock nut wrench is combined with a torque wrench Service Precautions.

2. CONNECT PCV VALVE HOSE

(a) Connect the PCV valve hose to the valve.





(b) Secure the hose with the clamp.

Text in Illustration





HINT
Make sure the direction of the hose clamp is as shown in the illustration.

3. INSTALL NO. 3 ENGINE COVER

(a) Install the No. 3 engine cover.





Text in Illustration





HINT
Position the No. 3 engine cover so that the arrow mark faces the front of the engine and install it.

4. INSTALL NO. 4 ENGINE COVER

(a) Install the No. 4 engine cover.





Text in Illustration





HINT
Position the No. 4 engine cover so that the arrow mark faces the front of the engine and install it.

5. INSTALL INTAKE MANIFOLD

(a) Install the intake manifold Installation.