Removal
PARKING BRAKE: PARKING BRAKE PEDAL: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
* w/ Navigation System:
After the engine switch is turned off, the display and navigation module display (navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.
Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Remove the lower No. 1 instrument panel airbag assembly Removal.
3. REMOVE REAR CONSOLE BOX ASSEMBLY
(a) w/ Refrigerated Cool Box:
Remove the rear console box sub-assembly Removal.
(b) w/o Refrigerated Cool Box:
Remove the rear console box sub-assembly Removal.
4. REMOVE CENTER AIRBAG SENSOR ASSEMBLY Removal
5. REMOVE YAW RATE AND ACCELERATION SENSOR Removal
6. REMOVE TURN SIGNAL FLASHER ASSEMBLY Removal
7. REMOVE TIRE PRESSURE WARNING ECU Removal
8. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
(a) Release the parking brake pedal.
(b) Disconnect the parking brake switch connector.
(c) Remove the 3 nuts and parking brake control pedal assembly.
9. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY
(a) Remove the transmission floor shift assembly Removal.
10. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY
(a) Remove the lock nut and adjusting nut.
(b) Remove the clip.
(c) Pull up the parking brake pedal claw.
(d) Remove the No. 1 parking brake cable assembly.
(e) Remove the 4 nuts and 3 bolts from the No. 1 parking brake cable assembly.
(f) Remove the lock nut, adjusting nut and No. 1 parking brake cable assembly from the parking brake equalizer.
11. REMOVE PARKING PEDAL PAD
(a) Remove the parking pedal pad.