Installation

BRAKE (REAR): REAR BRAKE FLEXIBLE HOSE: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL NO. 5 FLEXIBLE HOSE BRACKET

(a) Install the bracket with the bolt.

Torque : 29 Nm (296 kgf-cm, 21 ft-lbf)

NOTICE:
Make sure the bracket rotation stopper touches the installation position.

2. INSTALL NO. 6 FLEXIBLE HOSE BRACKET

(a) Install the bracket with the bolt.

Torque : 29 Nm (296 kgf-cm, 21 ft-lbf)

3. INSTALL REAR FLEXIBLE HOSE

(a) Connect the rear flexible hose to the connecting point with each brake tube, and then install 2 new clips.

(b) Using a union nut wrench, connect each brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
* Do not bend or damage the brake tube.
* Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
* Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Service Precautions.

(c) Connect the rear flexible hose to the connecting point with each brake tube, and then install 2 new clips.

(d) Using a union nut wrench, connect each brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
* Do not bend or damage the brake tube.
* Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
* Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Service Precautions.

4. INSTALL REAR FLEXIBLE HOSE LH

(a) Connect the rear flexible hose to the connecting point with the brake tube, and then install a new clip.

(b) Using a union nut wrench, connect the brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
* Do not bend or damage the brake tube.
* Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
* Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Service Precautions.

(c) Install the rear flexible hose and a new gasket to the rear disc brake cylinder with the union bolt.

Torque : 31 Nm (316 kgf-cm, 23 ft-lbf)

HINT
Install the rear flexible hose lock securely to the lock hole in the cylinder.

5. BLEED BRAKE LINE Service and Repair

6. INSTALL REAR WHEEL Installation