Sound Signal Circuit Between Multi-Display Controller And Television Display

AUDIO / VIDEO: REAR SEAT ENTERTAINMENT SYSTEM: Sound Signal Circuit between Multi-display Controller and Television Display
- Sound Signal Circuit between Multi-display Controller and Television Display

DESCRIPTION

This is the sound signal circuit between the multi-display controller sub-assembly and the television display assembly RH and LH.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER - TELEVISION DISPLAY RH AND LH)

(a) Disconnect the H17 multi-display controller sub-assembly connector.

(b) Disconnect the g1 television display assembly RH connector.

(c) Disconnect the g2 television display assembly LH connector.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table