Side Monitor System

PARK ASSIST / MONITORING: SIDE MONITOR SYSTEM: DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / Parking Assist Monitor System / Trouble Codes.

(e) Check the details of the DTCs Side Monitor System.

HINT
Parking assist ECU may output the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.





2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Operate the Techstream to clear the codes. Enter the following menus: Chassis / Parking Assist Monitor System / Trouble Codes.

(e) According to the display on the Techstream, select the trouble code data display with the clear button.