Installation

DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: INSTALLATION

1. INSTALL REAR PROPELLER SHAFT






(a) Align the matchmarks on the propeller shaft flange and transfer flange.
(b) Connect the propeller shaft with the 4 washers and 4 nuts.
Torque: 88 Nm (900 kgf-cm, 65 ft-lbf)






(c) Align the matchmarks on the propeller shaft flange and differential flange.
(d) Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.
Torque: 88 Nm (900 kgf-cm, 65 ft-lbf)
2. INSTALL TRANSFER HEAT INSULATOR






(a) Install the insulator with the 4 bolts.
Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)