Height Control Sensor (for Rear Side)

SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Rear Side): ADJUSTMENT

1. ADJUST REAR HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY
NOTICE:
- Make adjustments from the link that deviates the most from the specified vehicle height value.
- When the front and rear are at the same level, make adjustments from the front first.
- If adjustment cannot be completed through the vehicle height offset calibration, adjust the sensor link using the following procedure.





(a) Loosen the nut and adjust the link installation position by moving the height control sensor link up or down in the long hole of the bracket.
HINT:
When the link is moved 1 mm (0.0394 in.), the vehicle height changes by approximately 2 mm (0.0787 in.).

(b) Tighten the nut of the height control sensor link.
Torque: 5.6 Nm (57 kgf-cm, 50 in-lbf)
2. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
(a) Perform the vehicle height offset calibration Testing and Inspection.
3. PERFORM ZERO POINT CALIBRATION OF G SENSOR
(a) Perform the zero point calibration of the G sensor Calibration.
4. ADJUST FRONT WHEEL ALIGNMENT
(a) Adjust the front wheel alignment Front Wheel Alignment.
5. ADJUST HEADLIGHT ASSEMBLY
(a) Adjust the headlight Adjustments.