Installation

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: INSTALLATION

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL STEERING KNUCKLE OIL SEAL LH






(a) Using SST and a press, press in a new oil seal.
SST: 09950-60020
09951-01030
SST: 09950-70010
09951-07100
NOTICE:

- The oil seal is a non-reusable part.
- Do not damage the steering knuckle oil seal.


2. INSTALL STEERING KNUCKLE LH
(a) Install the steering knuckle to the front suspension upper arm with the nut.
Torque: 110 Nm (1122 kgf-cm, 81 ft-lbf)
(b) Install a new clip.
HINT:
If the holes for the clip are not aligned, tighten the nut up to another 60°.

3. CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH Installation

4. CONNECT TIE ROD END SUB-ASSEMBLY LH
(a) Connect the tie rod end LH to the steering knuckle with the nut.
Torque: 69 Nm (704 kgf-cm, 51 ft-lbf)
(b) Install a new cotter pin.
HINT:
If the holes for the cotter pin are not aligned, tighten the nut up to another 60°.

5. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
(a) Install the front axle hub Installation.
6. CONNECT FRONT SPEED SENSOR LH






(a) Using a 5 mm hexagon socket, install the speed sensor with the bolt.
Torque: 8.3 Nm (85 kgf-cm, 73 in-lbf)
NOTICE:

- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
- Make sure there is no foreign matter attached to the magnetic rotor.






(b) Install the skid control sensor clamp and sensor wire with the bolt.
Torque: 13 Nm (132 kgf-cm, 10 ft-lbf)
7. INSTALL FRONT WHEEL
Torque: 131 Nm (1336 kgf-cm, 97 ft-lbf)
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. CHECK SPEED SENSOR SIGNAL
(a) Check the speed sensor signal Test Mode Procedure.
10. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.
11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment Front Wheel Alignment.
12. ADJUST HEADLIGHT ASSEMBLY
(a) Adjust the headlight assembly Adjustments.