Installation

FRONT SUSPENSION: FRONT UPPER SUSPENSION ARM: INSTALLATION

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.





1. TEMPORARILY INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH
(a) Temporarily install the suspension upper arm with the 2 washers, bolt and nut.
HINT:
After stabilizing the suspension, tighten the nut.

2. CONNECT STEERING KNUCKLE LH
(a) Connect the steering knuckle to the suspension upper arm.
(b) Install the nut and a new cotter pin.
Torque: 110 Nm (1122 kgf-cm, 81 ft-lbf)
NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.





3. CONNECT SKID CONTROL SENSOR WIRE
(a) Connect the sensor wire to the steering knuckle and upper arm with the bolt and nut.
Torque: 13 Nm (133 kgf-cm, 9.6 ft-lbf)
4. STABILIZE SUSPENSION Installation

5. TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH
(a) Tighten the nut.
Torque: 185 Nm (1886 kgf-cm, 136 ft-lbf)
NOTICE:
Perform this procedure with all 4 wheels on the ground.

6. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH Installation

7. INSTALL FRONT FENDER APRON SEAL REAR LH






(a) Install the apron seal with the 4 clips.
8. INSTALL FRONT FENDER APRON SEAL LH






(a) Install the apron seal with the 4 clips.
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
(a) Perform the vehicle height offset calibration Testing and Inspection.
11. ADJUST FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH Height Control Sensor (for Front Side)

12. PERFORM ZERO POINT CALIBRATION OF G SENSOR
(a) Perform the zero point calibration of G sensor Installation.
13. ADJUST HEADLIGHT ASSEMBLY
(a) Adjust the headlight assembly Adjustments.