Installation

POWER ASSIST SYSTEMS: VANE PUMP: INSTALLATION

1. INSTALL VANE PUMP ASSEMBLY






(a) Install the vane pump with the 2 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)






2. CONNECT PRESSURE FEED TUBE
(a) Install a new gasket to the pressure feed tube.
(b) Connect the pressure feed tube with the union bolt.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)






3. CONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR
(a) Connect the connector.
(b) Attach the wire harness clamp.
4. CONNECT SUCTION HOSE






(a) Connect the suction hose to the vane pump assembly with the clip.
5. INSTALL FAN AND GENERATOR V BELT Installation

6. INSTALL AIR CLEANER ASSEMBLY Installation

7. INSTALL AIR CLEANER HOSE ASSEMBLY Installation

8. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

9. INSTALL FRONT FENDER APRON SEAL FRONT RH Installation

10. INSTALL FRONT WHEEL RH Installation

11. ADD POWER STEERING FLUID
12. BLEED POWER STEERING FLUID Power Steering System

13. INSPECT FOR POWER STEERING FLUID LEAK
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL