Rear Door Lock

DOOR LOCK: REAR DOOR LOCK: INSPECTION


1. INSPECT REAR DOOR LOCK ASSEMBLY LH
(a) Check the door lock motor operation.
(1) Apply battery voltage to the door lock connector and check the operation of the door lock.





OK:





- If the result is not as specified, replace the door lock assembly.

(b) Check the detection switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





- If the result is not as specified, replace the door lock assembly.

2. INSPECT REAR DOOR LOCK ASSEMBLY RH
(a) Check the door lock motor operation.
(1) Apply battery voltage to the door lock connector and check the operation of the door lock.





OK:





- If the result is not as specified, replace the door lock assembly.

(b) Check the detection switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





- If the result is not as specified, replace the door lock assembly.