Disassembly

EXTERIOR PANELS / TRIM: REAR BUMPER: DISASSEMBLY

1. REMOVE NO. 2 FRAME WIRE (w/ Intuitive Parking Assist System)
(a) Disconnect the 4 connectors.
(b) Detach the 14 clamps and remove the frame wire.





2. REMOVE NO. 2 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) Removal

3. REMOVE NO. 3 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) Removal

4. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) Removal

5. REMOVE NO. 3 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) Removal







6. REMOVE REAR BUMPER ENERGY ABSORBER
(a) Detach the 8 claws and remove the energy absorber.






7. REMOVE REAR FOG LIGHT ASSEMBLY LH
(a) Remove the 2 nuts.
(b) Detach the claw and remove the fog light.
8. REMOVE REAR FOG LIGHT ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.

9. REMOVE REAR LOWER BUMPER COVER
(a) Remove the clip and rear lower bumper cover.






10. REMOVE REAR NO. 2 STEP COVER
(a) Remove the 2 screws and 2 clips.
(b) Detach the 4 claws and remove the step cover.