Radio Receiver Power Source Circuit

AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: Radio Receiver Power Source Circuit

Radio Receiver Power Source Circuit

DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FUSE (RAD NO. 1, ACC)
(a) Disconnect the RAD NO. 1 fuse from the engine room relay block.
(b) Disconnect the ACC fuse from the main body ECU.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:

NG -- REPLACE FUSE
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (RECEIVER - BATTERY AND BODY GROUND)

(a) Disconnect the F1 receiver connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE