Rear View Monitor System

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: TERMINALS OF ECU

1. CHECK REAR TELEVISION CAMERA ASSEMBLY





(a) Disconnect the S5 camera connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.





If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the S5 camera connector.
(d) Measure the voltage according to the value(s) in the table below.





If the result is not as specified, the camera may have a malfunction.






(e) Using an oscilloscope, check waveform 1.






2. CHECK PARKING ASSIST ECU (w/ Wide View Front and Side Monitor System) Intuitive Parking Assist System

3. CHECK DISPLAY AND NAVIGATION MODULE DISPLAY (w/ Navigation System) Pinout Values and Diagnostic Parameters

4. CHECK MULTI-DISPLAY (w/o Navigation System) Pinout Values and Diagnostic Parameters