Installation

AUDIO / VIDEO: RADIO ANTENNA CORD: INSTALLATION

1. INSTALL ANTENNA CORD SUB-ASSEMBLY
(a) Attach the 7 clamps to install the antenna cord.





2. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
(a) Install the instrument panel safety pad Installation.
3. INSTALL ANTENNA CORD SUB-ASSEMBLY
(a) Apply new double-sided tape as shown in the illustration.
HINT:
Attach double-sided tape to the hatched areas shown in the illustration below.





(b) Align the red tape wound around the antenna cord with the V markings on the roof headlining and the notch at the rear of the headlining, and attach the antenna cord to the double-sided tape.
(c) Attach the 2 clamps and fit the antenna into the 3 ribs and the notch.
4. INSTALL ROOF HEADLINING ASSEMBLY
(a) Install the roof headlining Installation.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. INSTALL ENGINE ROOM SIDE COVER LH Installation

7. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.