Air Cleaner Body - Removal

REMOVAL





1. Disconnect and isolate the negative battery cable.
2. Remove the engine cover (1).





3. Disconnect the electrical connector (3) from the Inlet Air Temperature (IAT) sensor.
4. Loosen the clamp (4) at the throttle body.
5. Disconnect the fresh air makeup hose (2) from the air cleaner body.
6. Disengage the coolant hose from the two retainers (6).
7. Remove the two bolts (5) from the air inlet hose.
8. Disengage the air inlet hose from the throttle body and pull the air cleaner body (1) straight up off of the three locating pins.