Air Cleaner Body - Installation

INSTALLATION





1. Install the air cleaner body (1) straight down on the three locating pins while engaging the air inlet hose to the throttle body.
2. Install the two bolts (5) to the air inlet hose and tighten to 12 Nm (106 in. lbs.).
3. Engage the coolant hose to the two retainers (6).
4. Install the fresh air makeup hose (2) to the air cleaner body.
5. Tighten the clamp (4) at the throttle body to 4 Nm (35 in. lbs.).
6. Connect the electrical connector (3) to the Inlet Air Temperature (IAT) sensor.





7. Install the engine cover (1).
8. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).