LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Wrangler V6-3.6L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Head Assembly >> Rocker Arm Assembly >> Service and Repair >> Removal and Replacement >> Valve Rocker Arm - Installation

Valve Rocker Arm - Installation






INSTALLATION






NOTE: The LH cylinder head rocker arms are shown, the RH cylinder head rocker arms are similar. If the rocker arms are being reused, reassemble them into their original locations.

1. Lubricate the rocker arms with clean engine oil before installation.
2. Install the rocker arm(s) (1).
3. Install the camshaft(s), phasers, cylinder head cover(s) and upper intake manifold Camshaft - Installation
4. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).

scientia non olet · About LEMON Manuals