Power Brake Booster - Removal

REMOVAL

NOTE: LHD shown in graphics. The removal and installation procedures and torques specs are the same for the RHD.

1. Remove the master cylinder.
2. Disconnect vacuum hose from booster check valve.
3. Remove retaining clip that secures booster push rod to brake pedal and slide the rod off the pin.




4. Remove the nuts (1) attaching booster mounting plate to the front cowl panel.
5. In engine compartment, slide booster and mounting plate out of the cowl panel, and remove the booster assembly from engine compartment.





6. Remove booster mounting nuts (2) from the mounting plate (1).
7. Disconnect the clutch pedal from the clutch M/C if equipped.
8. Remove the booster from the mounting plate (1).