Center Console - Installation

INSTALLATION





1. Position the console (2) over the shifters and brake levers and seat fully.
2. Install the four screws (3).





3. Position the bezel (2) over the shifters seat the clips fully.
4. Install the cup holder and ash receiver, if equipped.
5. If equipped, position the transfer case shifter knob (1) onto the shift shaft, a audible click should be heard when the shifter knob is fully seated.





6. Seat the shifter boot (2) onto the console bezel (1) and seat fully.
7. Connect battery negative cable.





8. Connect the electrical connectors (2), if equipped.
9. Position the rear bezel (1) back into place and seat the clips fully.
10. Install the 115V power outlet. 115 V Power Outlet
11. Install the 12V power outlet. 12 V Power Outlet