Radio - Installation

INSTALLATION

WARNING: On vehicles equipped with airbags, before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.





1. Connect the electrical and antenna connectors and install the radio.
2. Install the radio mounting fasteners.
3. Install the center bezel Instrument Panel Center Bezel - Installation.
4. Connect the battery negative cable.

NOTE: REQ RADIO, After installation of the radio, remove the radio from "Transportation Mode" by pulling the IOD fuse or using the scan tool and perform a battery reset.