Vibration Damper - Installation

INSTALLATION

Special Tools:















1. Install crankshaft vibration damper using the forcing screw, nut, and thrust bearing/washer (3) from Special Tool (1).

NOTE: To minimize friction and prolong tool life, lubricate the threads on the forcing screw of Special Tool.

2. Position vibration damper on crankshaft.
3. Screw Special Tool (1) into crankshaft until the bolt seats. Turn the nut to install damper until it seats fully.
4. Remove Special Tool.
5. Install vibration damper bolt. Torque bolt to 54 Nm (40 ft. lbs.).
6. Install the accessory drive belt. Serpentine Accessory Drive Belt - Installation
7. Connect negative cable to battery.