LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2011 >> Compass 4WD L4-2.4L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Engine Lubrication >> Oil Cooler >> Service and Repair >> Engine Oil Cooler - Installation

Engine Oil Cooler - Installation






INSTALLATION





1. Replace oil cooler seal (1).
2. Lubricate seal and position oil cooler to oil filter adapter, aligning notch to tab.
3. Install oil cooler connector bolt (2). Tighten connector bolt to 49 Nm (36 ft. lbs.).





4. Install oil filter (3).
5. Connect oil cooler coolant hose.
6. Lower vehicle.
7. Fill cooling system Service and Repair.

scientia non olet · About LEMON Manuals