Installation

INSTALLATION





1. Install axle shaft (1) in axle tube (2) and engage into side gear splines.





2. Lubricate bearing bore and seal lip with gear lubricant.
3. Install C-lock (1) in axle shaft end, then push axle shaft outward to seat C-lock in side gear.





4. Install pinion mate shaft (1) into differential case (2) and through thrust washers and differential pinions.





5. Align hole in shaft with hole in the differential case and install lock screw (4) with Mopar Lock AND Seal or equivalent on the threads. Tighten lock screw to 26 Nm (19 ft. lbs.).
6. Install differential cover.
7. Install rear brake components.