Removal

CLEVIS BRACKET BUSHING

1. Remove the tire and wheel assembly.
2. Remove the disc brake rotor Brake Rotor - Removal.
3. Remove the wheel speed sensor Front.
4. Remove the lower stabilizer link at the lower control arm.
5. Remove the lower clevis bolt at the control arm.




6. Remove the upper ball joint nut.
7. Separate the upper ball joint from the knuckle using special tool 9360 separator (2).
8. Lower the control arm enough to install the press tool.






NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper operation during the removal and installation process.

9. Press the bushing (3) out using special tools C-4212F (Press) (1), 9956 (receiver) (4) and 9653-1 (driver) (2).