Cover Assembly - Removal

REMOVAL





1. Open the front drive assembly about 300 mm (12 inches).
2. Separate the headliner hook and loop strip (3) and expose the drive mechanism (1).
3. Remove the five screws (2) and separate the cover assembly from the front drive (1).





4. Move the front drive forward to gain access to the nylon pin (2).
5. Carefully remove the two nylon pins (2) and separate the cover assembly (1) from the drive assembly cap (3).





6. Open the rear drive assembly about 300 mm (12 inches).
7. Separate the headliner hook and loop strip (3) and expose the drive mechanism.
8. Remove the five screws (2) and separate the cover assembly from the drives (1).





9. Starting at the front, separate the lift arms from the sliders and remove the top assembly.