LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2010 >> Commander 2WD V6-3.7L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Block Assembly >> Harmonic Balancer - Crankshaft Pulley >> Service and Repair >> Vibration Damper - Installation

Vibration Damper - Installation






INSTALLATION






CAUTION: To prevent severe damage to the Crankshaft, Damper or Damper Installer 8512A, thoroughly clean the damper bore and the crankshaft nose before installing Damper.

1. Position the damper onto crankshaft.
2. Assemble the damper installer 8512A (2) , and the pressing cup (1) from A/C hub installer 6871.
3. Coat the threads of damper installer 8512A with Mopar(R) Nickel Anti-Seize or equivalent.





4. Using the damper installer 8512A (1), and the pressing cup from the A/C hub installer 6871, press the damper onto crankshaft.
5. Install and tighten the vibration damper bolt to 175 Nm (130 ft. lbs.).
6. Install the cooling fanCooling Fan - Installation.
7. Install the accessory drive beltSerpentine Accessory Drive Belt - Installation.
8. Connect the negative cable to battery.

scientia non olet · About LEMON Manuals