Power Steering Pump - Installation

5.7L





1. Install pulley on pump if removed Power Steering Pump Pulley - Installation.
2. Install 3 pump mounting bolts (1) and tighten to 28 Nm (21 ft. lbs.).
3. Install the pressure hose on the pump and tighten the nut to 47 Nm (35 ft. lbs.).
4. Reconnect the supply hose (2) at the pump (1).
5. Install the drive belt,Serpentine Accessory Drive Belt - Installation.
6. Install the air intake tube.
7. Fill the system with power steering fluid.
8. Bleed the hydraulic fan system using a scan tool Power Steering System Bleeding.