LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander 4WD V6-3.7L >> Repair and Diagnosis >> Accessories and Optional Equipment >> Radio, Stereo, and Compact Disc >> Radio/Stereo >> Service and Repair >> Removal and Replacement >> Radio - Installation

Radio - Installation






INSTALLATION





1. Connect the antenna cable(s) to the radio.
2. Connect the electrical connectors to the radio.
3. Position the radio into the instrument panel. Install and tighten mounting the fasteners.
4. Install instrument panel bezel Instrument Panel Bezel - Installation.

NOTE: REQ RADIO, After installation of the radio, remove the radio from "Transportation Mode" by pulling the IOD fuse or using the scan tool and perform a battery reset.

scientia non olet · About LEMON Manuals