LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander 2WD V8-5.7L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Head Assembly >> Valve Cover >> Service and Repair >> Cylinder Head Cover - Removal

Cylinder Head Cover - Removal







REMOVAL





1. Disconnect battery negative cable.
2. Disconnect ignition coil connector (1).
3. Remove ignition coil retaining bolts (3).




4. Remove ignition coil (1).




5. Remove cylinder head cover retaining bolts.




6. Remove cylinder head cover (1).

NOTE: The gasket (2) may be used again, provided no cuts, tears, or deformation has occurred.
scientia non olet · About LEMON Manuals